ikbguИзвестия Кабардино-Балкарского государственного университетаProceedings of the Kabardino-Balkarian State University2221-7789Kabardino-Balkarian State University named after Kh. M. Berbekov10.31143/2221-7789-2024-1-41-45XDEYOHikbgu-75Research ArticleХимияChemistryИСПОЛЬЗОВАНИЕ АГРООТХОДА – СКОРЛУПЫ АРАХИСА В КАЧЕСТВЕ НАПОЛНИТЕЛЯ В ПОЛИМЕРНЫХ КОМПОЗИТАХ НА ОСНОВЕ ПОЛИЭТИЛЕНА НИЗКОЙ ПЛОТНОСТИUSE OF AGRO WASTE – PEANUT SHELL AS FILLER IN POLYMER COMPOSITES BASED ON LOW DENSITY POLYETHYLENEАрзумановаН. Б.ArzumanovaN. B.arzumanova-nushaba@rambler.ruКахрамановН. Т.KakhramanovN. T.arzumanova-nushaba@rambler.ruИнститут полимерных материалов Министерства науки и образования Азербайджанской РеспубликиInstitute of Polymer Materials of Ministry of Science and Education Republic of Azerbaijan2024300320241414145Copyright © Арзуманова Н.Б., Кахраманов Н.Т., 20242024Арзуманова Н.Б., Кахраманов Н.Т.Arzumanova N.B., Kakhramanov N.T.Данная работа распространяется под лицензией Creative Commons Attribution 4.0.This work is licensed under a Creative Commons Attribution 4.0 License.https://www.izvestiakbsu.ru/jour/article/view/75

Исследованы физико-механические свойства композитных материалов в зависимости от концентрации скорлупы арахиса. Концентрацию скорлупы арахиса в композитах варьировали в пределах от 1 до 30 масс. %. Показано, что при повышении концентрации скорлупы арахиса в полимерной матрице до 30 масс. % значение прочности и относительного удлинения при растяжении уменьшается. Исследовано водопоглощение композитных материалов. Проведенное исследование показало потенциальную применимость скорлупы арахиса в качестве натурального наполнителя для полиэтилена низкой плотности.

The physicomechanical properties of composite materials were investigated depending on the peanut shell concentration. The peanut shell concentration in the composites was varied in the range from 1 to 30 wt. %. It has been shown that with an increase in the peanut shell concentration in the polymer matrix up to 30 wt. %, the value of strength and elongation at break decreases. The water absorption of composite materials was studied. The carrying out study has shown the potential applicability of peanut shells as natural filler for low density polyethylene.

биокомпозитагроотходскорлупа арахисаполиолефинэкологически чистыйbiocompositeagro wastepeanut shellpolyolefineco friendlyReferencesMotaung T.E., Linganiso L.Z. Critical review on agro waste cellulose applications for biopolymers // International Journal of Plastics Technology. 2018. V. 22, N 1. P. 185–216.Motaung T.E., Linganiso L.Z. Critical review on agro waste cellulose applications for biopolymers // International Journal of Plastics Technology. 2018. V. 22, N 1. P. 185–216.Nevarez L.M., Casarrubias L.B., Canto O.S., Celzard A., Fierro V., Gomez R.I., Sanchez G.G. Bi- opolymers-based nanocomposites: membranes from propionated lignin and cellulose for water purification // Carbohydrate Polymers. 2011. V. 86, N 2. P. 732–741.Nevarez L.M., Casarrubias L.B., Canto O.S., Celzard A., Fierro V., Gomez R.I., Sanchez G.G. Bi- opolymers-based nanocomposites: membranes from propionated lignin and cellulose for water purification // Carbohydrate Polymers. 2011. V. 86, N 2. P. 732–741.Chatterjee A., Singh H. Development and characterization of peanut shell flour-polypropylene com- posite // Journal of The Institution of Engineers (India): Series D. 2019. V. 100, N 2. P. 147–153.Chatterjee A., Singh H. Development and characterization of peanut shell flour-polypropylene com- posite // Journal of The Institution of Engineers (India): Series D. 2019. V. 100, N 2. P. 147–153.Akil H.M., Omar F.M., Mazuki A.A.M., Safiee S. Kenaf fiber reinforced composites: A review // Materials and Design. 2011. V. 32, N 8-9. P. 4107–4121.Akil H.M., Omar F.M., Mazuki A.A.M., Safiee S. Kenaf fiber reinforced composites: A review // Materials and Design. 2011. V. 32, N 8-9. P. 4107–4121.Shalwan A., Yousif B.F. In State of Art: mechanical and tribological behaviour of polymeric compo- sites based on natural fibres // Materials and Design. 2013. V. 48. P. 14–24.Shalwan A., Yousif B.F. In State of Art: mechanical and tribological behaviour of polymeric compo- sites based on natural fibres // Materials and Design. 2013. V. 48. P. 14–24.Gholampour A.A., Ozbakkaloglu T. A review of natural fiber composites: properties, modification and processing techniques, characterization, applications // Journal of Materials Science. 2020. V. 55, N 3.Gholampour A.A., Ozbakkaloglu T. A review of natural fiber composites: properties, modification and processing techniques, characterization, applications // Journal of Materials Science. 2020. V. 55, N 3.P. 829–892.P. 829–892.Arzumanova N.B., Kakhramanov N.T. Polymer biocomposites based on agro waste: Part II. Husk, stalk and straw of some agricultural crops as dispersed filler // New Materials, Compounds and Applications. 2020. V. 4, N 3. P. 153–172.Arzumanova N.B., Kakhramanov N.T. Polymer biocomposites based on agro waste: Part II. Husk, stalk and straw of some agricultural crops as dispersed filler // New Materials, Compounds and Applications. 2020. V. 4, N 3. P. 153–172.Sutivisedsak N., Cheng H.N., Burks C.S. Johnson J.A., Siegel J.P., Civerolo E.L., Biswas A. Use of Nutshells as Fillers in Polymer Composites // Journal of Polymer Environment. 2012. V. 20, N 2. P. 305–314.Sutivisedsak N., Cheng H.N., Burks C.S. Johnson J.A., Siegel J.P., Civerolo E.L., Biswas A. Use of Nutshells as Fillers in Polymer Composites // Journal of Polymer Environment. 2012. V. 20, N 2. P. 305–314.Perea-Moreno, M.A., Manzano-Agugliaro F., Hernandez-Escobedo Q., Perea-Moreno A.J. Peanut shell for energy: properties and its potential to respect the environment // Sustainability. 2018. V. 10, N 9. P. 3254.Perea-Moreno, M.A., Manzano-Agugliaro F., Hernandez-Escobedo Q., Perea-Moreno A.J. Peanut shell for energy: properties and its potential to respect the environment // Sustainability. 2018. V. 10, N 9. P. 3254.Raju G.U., Kumarappa S. Experimental study on mechanical properties of groundnut shell particle- reinforced epoxy composites // Journal of Reinforced Plastics and Composites. 2011. V. 30, N 12. P. 1029–1037.Raju G.U., Kumarappa S. Experimental study on mechanical properties of groundnut shell particle- reinforced epoxy composites // Journal of Reinforced Plastics and Composites. 2011. V. 30, N 12. P. 1029–1037.Pickering K.L., Efendy M.G.A., Le T.M. A review of recent developments in natural fibre compo- sites and their mechanical performance // Composites Part A: Applied Science and Manufacturing. 2016. V. 83.Pickering K.L., Efendy M.G.A., Le T.M. A review of recent developments in natural fibre compo- sites and their mechanical performance // Composites Part A: Applied Science and Manufacturing. 2016. V. 83.P. 98–112.P. 98–112.Balla V.K., Kate K.H., Satyavolu J., Singh P., Dattatreya Tadimeti J.G. Additive manufacturing of natural fiber reinforced polymer composites: Processing and prospects // Composites Part B: Engineering. 2019. V. 174. Р. 106956.Balla V.K., Kate K.H., Satyavolu J., Singh P., Dattatreya Tadimeti J.G. Additive manufacturing of natural fiber reinforced polymer composites: Processing and prospects // Composites Part B: Engineering. 2019. V. 174. Р. 106956.Obasi H.C., Onuegbu G.C. Biodegradability and mechanical properties of low density polyeth- ylene/waste maize cob flour blends // International Journal of Applied Science and Engineering Research. 2013. V. 2, N 3. P. 242–249.Obasi H.C., Onuegbu G.C. Biodegradability and mechanical properties of low density polyeth- ylene/waste maize cob flour blends // International Journal of Applied Science and Engineering Research. 2013. V. 2, N 3. P. 242–249.Nurshamila S.B., Hanafi I., Nadras O. The effect of Rattan filler loading on properties of Rattan powder filled polypropylene composites // BioResources. 2012. V. 7, N 4. P. 567–5690.Nurshamila S.B., Hanafi I., Nadras O. The effect of Rattan filler loading on properties of Rattan powder filled polypropylene composites // BioResources. 2012. V. 7, N 4. P. 567–5690.Akil H.M., Santulli C., Sarasini F., Tirillo J., Valente T. Environmental effects on the mechanical behaviour of pultruded jute/glass fibre-reinforced polyester hybrid composites // Composites Science and Technology. 2014. V. 94. P. 62–70.Akil H.M., Santulli C., Sarasini F., Tirillo J., Valente T. Environmental effects on the mechanical behaviour of pultruded jute/glass fibre-reinforced polyester hybrid composites // Composites Science and Technology. 2014. V. 94. P. 62–70.Sreekumar P.A., Joseph K., Unnikrishnan G., Thomas S. A comparative study on mechanical prop- erties of sisal-leaf fibre-reinforced polyester composites prepared by resin transfer and compression moulding techniques // Composites Science and Technology. 2007. V. 67, N 3-4. P. 453–461.Sreekumar P.A., Joseph K., Unnikrishnan G., Thomas S. A comparative study on mechanical prop- erties of sisal-leaf fibre-reinforced polyester composites prepared by resin transfer and compression moulding techniques // Composites Science and Technology. 2007. V. 67, N 3-4. P. 453–461.Zhang K., Liang W., Wang F., Wang Z. Effect of water absorption on the mechanical properties of bamboo/glass-reinforced polybenzoxazine hybrid composite // Polymers and Polymer Composites. 2021. V. 29, N 1. P. 3–14.Zhang K., Liang W., Wang F., Wang Z. Effect of water absorption on the mechanical properties of bamboo/glass-reinforced polybenzoxazine hybrid composite // Polymers and Polymer Composites. 2021. V. 29, N 1. P. 3–14.

The authors declare that there are no conflicts of interest present.