INVESTIGATION OF THE EFFECT OF EXTRUSION MULTIPLICITY ON THE PROPERTIES OF CARBON FIBER-FILLED POLYETHERETHERKETONE
https://doi.org/10.31143/2221-7789-2023-3-88-93
EDN: ZOJZHM
Abstract
The paper shows that reapet the reprocessing of composites based on polyetherketone and carbon fiber is accompanied by insignificant additional destruction of the fibrous filler, while it was found that the viscosity of the initial polymer matrix has practically no effect on the degree of fiber destruction. despite the difference in shear stresses.
About the Authors
A. F. Tlupov
Kabardino-Balkarian State University
Russian Federation
Russian Federation
Kh. V. Musov
Kabardino-Balkarian State University
Russian Federation
Russian Federation
A. A. Zhansitov
Kabardino-Balkarian State University
Russian Federation
Russian Federation
A. L. Slonov
Kabardino-Balkarian State University
Russian Federation
Russian Federation
S. Y. Khashirova
Kabardino-Balkarian State University
Russian Federation
Russian Federation
I. V. Musov
Kabardino-Balkarian State University
Russian Federation
Russian Federation
E. V. Rzhevskaya
Kabardino-Balkarian State University
Russian Federation
Russian Federation
References
1. Стеблев А.А., Стеблев М.А. Понятие о полимерных композиционных материалах (ПКМ) // Символ науки: международный научный журнал. 2020. № 9. С. 112.
2. Белова Н.А. Композитные материалы на основе углеродных волокон // Молодой ученый. 2015.
3. № 24.1 (104.1). С. 5–7.
4. Lu Z.P., Friedrich K. On sliding friction and wear of PEEK and its composites // Wear. 1995. V. 181– 183, N 2. P. 624–631.
5. Bijwe J., Sen S., Ghosh A. Influence of PTFE content in PEEK-PTFE blends on mechanical proper- ties and tribo-performance in various wear modes // Wear. 2005. V. 258, N 10. P. 1536–1542.
6. Панов Ю.Т., Чижова Л.А., Ермолаева Е.В. Современные методы переработки полимерных ма- териалов. Экструзия. Литье под давлением: учеб. пособие. Владимир: Изд-во ВолГУ, 2013. 128 с.
7. Полимерные смеси. Т. II: Функциональные свойства / под ред. Д.Р. Пола и К.Б. Бакнелла. СПб.: Научные основы и технологии, 2009. 618 с.
8. Слонов А.Л., Жанситов А.А., Ржевская Е.В., Хакулова Д.М., Сапаев Х.Х., Шетов Р.А., Хаширова С.Ю. Влияние длины и концентрации углеродных и стеклянных волокон на свойства полифениленсульфона // Химические волокна. 2018. № 4. С. 78–82.
9. Slonov A., Musov I., Zhansitov A., Rzhevskaya E., Khakulova D., Khashirova S. The E_ect of Modi- fication on the Properties of Polyetherimide and Its Carbon-Filled Composite // Polymers. 2020. V. 12. Р. 1056.
Review
For citations:
Tlupov A.F., Musov Kh.V., Zhansitov A.A., Slonov A.L., Khashirova S.Y., Musov I.V., Rzhevskaya E.V. INVESTIGATION OF THE EFFECT OF EXTRUSION MULTIPLICITY ON THE PROPERTIES OF CARBON FIBER-FILLED POLYETHERETHERKETONE. Proceedings of the Kabardino-Balkarian State University. 2023;13(3):88-93. (In Russ.) https://doi.org/10.31143/2221-7789-2023-3-88-93. EDN: ZOJZHM
Views:
28
JATS XML
Email this article 